Changhong Electric LT1712E Manuel d'utilisateur télécharger pdf (Page 13)

PAGE

Installation

1. Remove the LCD TV from the box and place it on a flat surface in a well-ventilated

location.

2. Connect the output terminal of RF cable to the corresponding TV RF signal input

terminal. The LCD TV is a high-tech digital product. Do use quality RF cable to obtain

optimal results.

3. Connect the output terminal of the AV devices such as YPbPr, DVD to the corresponding

terminal of the LCD TV.

4. Connect one end of the VGA terminal to the corresponding signal source terminal, and

connect the other end to the corresponding LCD TV terminal. Screw down the screws

on both sides to secure it.

5. Ensure that every AV signal cord is correctly connected to the corresponding interface.

6. Connect one end of the AC power/power adapter cord to the power input jack of the LCD

TV, then plug the other end to the corresponding jack.

7. The panel can be tilted upwards by no more than 10

to achieve better visual angle. When

doing so, rotate the TV with two hands, one to fix the pedestal while the other to tilt the

panel. Take great care and do this in a moderate pressure in case any accidents

happen.(only for LT1512E LT1712E LT2012E)

General Operation

Switching the TV On

1. In Standby mode, press【

】on the remote control or front panel to enter to Power On

mode.

2 The indicator is red when the TV is in Standby mode.

Switching the TV Off

1. Press【】on the remote control or on the front panel to switch off the TV

2. Unplug the AC power/power adapter cord from the power outlet supply after turning off

the power to switch the TV off completely.

Caution: The TV will be shut off automatically when the power trips. Do unplug the

power cord from the AC outlet if so. The last TV mode will appear when

power resumes

Do not turn on/off the TV too often

Auto Off If there is no Signal Input

The TV will enter into Standby mode after 15 minutes when there is no signal input in TV

source; The TV enter into power saving mode after 30 seconds when there is no signal input

in PC source.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Pas de commentaire

Changhong Electric LT1712E Manuel d'utilisateur Page 13